Free A/C Inspection Includes: visual inspection of belts, hoses and temperature inspection at the air ducts. Call us before it gets too hot!
The disk brake system is what most modern vehicles are using primarily. This is a hydraulic system that should be inspected regularly to ensure your safety. Disk brakes are relatively easy to understand. The diagram below will make it even easier.
When the brake pedal is pushed down, a plunger inside the master cylinder forces brake fluid through a system of high-pressure tubes and hoses to each wheel’s brake. The master cylinder is usually found in the engine compartment, on the firewall on the driver’s side. The most common problem with master cylinders is an internal leak. You will notice a slow sinking of the brake pedal to the floor when this happens. If you feel this is a problem you are experiencing, come in and have us inspect your brake system today.
What is Brake Fluid?
Brake fluid is hydraulic fluid specially designed for brake systems. It will defy high temperatures without boiling, and cold temperatures without thickening. The current standard for brake fluid that has been set by the Department of Traffic is DOT-3. Brake fluid levels will drop slightly as the brake pads wear, this is normal but if fluid levels drop substantially in short period of time, you may need to have your brakes checked. Fluid cannot be compressed in a sealed system, but air can… if there is air present in the brake fluid, the brake pedal will have a sponginess effect, and braking efficiency is greatly reduced. If your brakes have this sponginess feel to the pedal, the brake system must be bled to remove air from the brake lines. This is also a good reason to have your brakes checked.
Benefits of Disk Brakes
Disk Brakes are used to stop everything from cars, trains to jets! Disk brakes wear longer, adjust automatically, self-clean, and resist water better than any other brake system around. The design of the disk can vary from vehicle to manufacturer. Vents or holes in the disk help to cool the disk, as heat can build up quick when the brakes are applied. When changing brake pads, it is a good idea to “turn” the brake rotor (disk). This shaves off old brake pad material left in the rotor, also puts a new surface on the rotor. Rotors can only be turned to a safe thickness of the rotor. Our technicians can inspect your brake rotors and tell you if your rotors can be turned safely, or if they need to be replaced.
Front or Rear Disk Brake Special
Replace Brake Pads
Price Includes Labor and Pads Only. Rotors are extra if needed.
Regular price: $149.95
* for most cars.
Welcome to the Bypass Garage. If you have visited out About page, you know a little bit of the history of this American Dream come true. Here are some more photos from the past.
These were taken in 1982 at the Bypass Plaza in Brooksville, Florida.